Rotor Install
These are the step-by-step instructions to installing rotors either aftermarket or OEM on your honda prelude.
I bought the Power Slot Rotors on sale for $80 each w/ free shipping
I bought the Power Stop Pads at Pep Boys Auto for $20
- Remove the Wheel
- Remove one Caliper bolt and swing the caliper up (Bolts on outer section pictured)
- Remove the pads from the caliper
- Remove the mounting bracket for the brake line on arm (allows for more caliper movement)
- Remove the large bolts behind the caliper assembly
- (Bolts on inner section pictured)
- Remove entire assembly and rest on lower control between calipers.
- (prevent the brake line from being stressed)
- (Pictured in upper right corner)
- Use a Impact Wrench with Philips head #2 to remove the 2 Philips screws
- Remove the Rotor… may be difficult.. bang with hammer several times to loosen
- Check the rotor for abnormal wear.. as seen above.. deep grooves in rotor wall.
- Hub should now look like picture below without rotor
- Install new rotor as seen in picture, Power Slot Rotors
- (Pay Special attention to the Right or Left Rotor.. important in slotted rotors)
- Right rotor goes on passenger side and left rotor goes on drivers side
- Slide new rotor on and place 2 screws back in. hit only once with impact wrench
- Compress the piston back into the cylinder wall
- Put retainer & caliper back on rotor (rotor swung up)
- slide new power stop pads, NEVER REUSE PADS, in grooves on retainer
- Slide the calipers over the pads and bolt down.
- Put the wheel back on
That should be it… Enjoy!